SkyTrak 6036 Service Manual - Manual (Page 115)

5-9 6036, 6042, 8042, 10042, 10054
Axles, Drive Shafts, Wheels and Tires
12. Remove the blocks from the front and rear of both
tires on the other axle.
Note: ALWAYS use new o-rings when servicing the
machine.
13. Install new o-rings into the fittings. Lubricate the
o-rings with clean hydraulic oil.
14. Uncap and connect the steering and brake lines at
their axle fittings.
15. Check the hydraulic reservoir oil level.
16. Properly connect the battery.
17. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
18. Start the engine. Turn the steering wheel several
times lock to lock, operate the frame tilt function
several times in both directions and check the
function of the brakes. Check for hydraulic leaks, and
tighten or repair as necessary.
19. Front Axle: Install the front access panel.
20. Close and secure the rear door.
Note: The service brake circuit will need to be bled after
axle installation. Refer to Section 8.7.5, “Brake
Bleeding.”
5.6.6 Axle Replacement
(8042, 10042 & 10054)
a. Outrigger Removal (10042 & 10054 only)
On Models 10042 and 10054 equipped with outriggers, it
is necessary to remove the outrigger assembly before
removing the front axle.
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake, straighten all
wheels and shut the engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
5. Label and disconnect the wiring harness connectors
at both outrigger cylinder pressure switches (4).
Remove the wire ties securing the wiring harness to
the outrigger cylinders.
6. Tie a length of string to each pressure switch wiring
connector, and pull harness out through openings
(5) at rear of outrigger housing.
7. Untie strings from wiring connectors and tape, or
otherwise secure ends of strings to outrigger
housing. These strings will be used to pull harness
through housing during installation.
MH3281
4
4
5