SkyTrak 6036 Service Manual - Manual (Page 186)

Hydraulic System
8-34 6036, 6042, 8042, 10042, 10054
8.8.2 Cylinder Pressure Checking
Attach 4000 psi (276 bar) gauge to test port on hydraulic
pump to check system pressure. For more information,
refer Section 8.3.1, “Pressure Checks and Adjustments.”
Note: If a hydraulic cylinder pressure is greater than
main control valve pressure, increase main control valve
pressure by adjusting the main relief. Generally, one half
turn clockwise will be adequate to check an individual
circuit. Activate circuit and if pressure is obtained turn
main relief counter clockwise one half turn. Re-check
main relief setting and adjust if necessary.
8.8.3 Steering Cylinders
The steer cylinder is attached to each axle center
housing.The steer cylinder assembly can be found in
Section 5.6, “Axle Assemblies.” The steer cylinder is
covered in the appropriate manufacturer’s axle literature.
AXLE CENTER SECTION
STEERING CYLINDER