SkyTrak 6036 Service Manual - Manual (Page 147)

7-11 6036, 6042, 8042, 10042, 10054
Engine
7.8 AIR CLEANER ASSEMBLY
Note: Refer to the appropriate Operation & Safety
Manual for your machine for the correct element change
procedure.
7.8.1 Air Cleaner Assembly Removal - ULS
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake, and shut the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
Note: Note orientation of pipe for reassembly. Pipe will
need to be aligned correctly for proper reassembly.
5. Loosen clamps securing exhaust pipe and air
cleaner hose and remove exhaust pipe and air
cleaner hose (15).
6. Remove air intake hose and pre-cleaner (16).
7. To complete removal it is necessary to disassemble
the air cleaner assembly.
8. Remove air cleaner cover and primary element (17).
9. Remove restriction indicator and remaining side
cover (18) from air filter body.
10. Remove three bolts securing air filter body to
weldment bracket (19).
11. Remove bolts securing weldment bracket to engine
(20) and tilt bracket forward to gain access to last
bolt (21). Remove last bolt.
12. Remove air cleaner body for replacement.
7.8.2 Air Cleaner Assembly
Installation - ULS
1. Reinstall components in reverse order of removal.
2. Attach air filter body to weldment body using all four
bolts (19, 21) removed earlier.
3. Secure weldment bracket to engine using bolts (20).
4. Reassemble restriction indicator and remaining side
cover (18) from air filter body.
CAUTION
NEVER run the engine with only the inner safety
element installed.
MAQ0550
15
16
MAQ0560
17
18
20
19
21