SkyTrak 6036 Service Manual - Manual (Page 126)

Axles, Drive Shafts, Wheels and Tires
5-20 6036, 6042, 8042, 10042, 10054
5. Attach a remote portable hydraulic pressurizing unit
to the parking brake gauge port (5) on the secondary
function manifold (6) mounted on the inside wall of
the frame on the left side next to the transmission.
6. Turn the key switch to the ON position, release the
park brake, and have an operator seated in the seat.
7. Pressurize the park brake with the pressurizing unit.
Close the pump needle valve on the pressurizing
unit.
8. Clear the area of all unnecessary personnel.
9. Remove the blocks from the wheels. Tow the
machine to a secure location.
10. Remove the hydraulic pressurizing unit.
Note: Without engine power, service brake power is
reduced. Only the rear service brakes will function when
the brake pedal is depressed. Steering is not possible
and the machine will only travel in the direction that the
wheels were last turned. Tow or push the machine at a
very slow speed.
CAUTION
DO NOT exceed 575 psi (40 bar) when pressurizing
the park brake. Applying too much pressure may
damage the brake seals.
OH1841
5
6
FRONT OF
MACHINE
8042, 10042 & 10054