SkyTrak 6036 Service Manual - Manual (Page 146)

Engine
7-10 6036, 6042, 8042, 10042, 10054
The following steps may be required to achieve distance
(C) (Expanded web).
• Loosen the turbocharger clamp to allow rotation of
the top exhaust pipe (11). Do Not remove clamp.
• Pull up and out on exhaust pipe (11) to allow for a
straight line and expansion of the flex pipe.
• Tighten the turbocharger clamp while holding the
exhaust pipe (11) in place.
• If the flex pipe is in a “S” shape, loosen the band
clamp (17) securing the muffler.
• Rotate the muffler inlet tube forward until the flex
pipe becomes straight.
• It may be necessary to pull the muffler closer to the
frame until the flex pipe becomes straight.
10. Tighten the muffler band clamp and all remaining
clamps (10).
11. Properly connect the battery.
12. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
13. Start engine and check for exhaust leaks at all
exhaust connections. Adjust or repair as needed.
14. Close and secure the rear door.