SkyTrak 6036 Service Manual User Manual

Page 240

Advertising
background image

Stabil-TRAK™

System and Boom Interlock System

10-12

6036, 6042, 8042, 10042, 10054

Stabil-TRAK System Test Procedures

Step 1

a. Place the vehicle on a level surface with 0° level.

b. Have the boom fully retracted and horizontal.

c. Place an 8in (203 mm) wood or cement block in front of the front left tire.

d. Enter the vehicle.

e. Fasten the seat belt.

f. Turn the key to the RUN position.

g. Check to be sure the Stabil-TRAK™

light is OFF.

Step 2

a. Start the engine.

b. Turn the parking brake switch OFF.

c. Move the range select lever to (1) FIRST gear.

d. Move the travel select lever to the (F) FORWARD position.

e. Drive the vehicle up on the block.

f. Use the frame level control to level the vehicle back to 0°.

Step 3

a. Depress the service brake pedal.

b. Move the travel select lever to the (N) NEUTRAL position.

c. Raise the boom to exactly 60°. The Stabil-TRAK™

light should come ON when the boom angle is at

about 40° and remain ON.

Step 4

a. Use your left foot to depress the service brake pedal.

b. With range select lever in (2) SECOND gear, move travel select lever to (R) REVERSE position.

c. Ease your left foot partially off the service brake pedal, make sure that the Stabil-TRAK™

light

remains ON.

d. With your right foot, increase the engine rpm slightly, as necessary, just enough to back the vehicle

off the block. While backing off the block, the front left tire should remain off the ground.

IMPORTANT: Perform Steps 5 thru 9 with the engine rpm at idle.

Step 5

a. Keep the service brake pedal depressed.

b. Move the travel select lever to the (N) NEUTRAL position.

c. Take your foot off the service brake pedal. The Stabil-TRAK™

light should remain ON and the front

left tire should remain off the ground.

Step 6

a. With the travel select lever in the (N) NEUTRAL position, engage the parking brake switch.

b. Move the travel select lever to the (F) FORWARD position. The Stabil-TRAK™

light should remain

ON and the front left tire should remain off the ground.

FREE PIVOT

MOD

E

LOCK

ED MODE

Ser

v

ic

e

B

rake

T

e

st

Neut

ral T

e

st

P

a

rk Brake T

e

st

OH2500

Advertising
This manual is related to the following products: