SkyTrak 6036 Service Manual - Manual (Page 215)

9-27 6036, 6042, 8042, 10042, 10054
Electrical System
9.10.8 Outrigger Pressure Switches
(10054 Only)
a. Removal
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel select
lever in the (N) NEUTRAL position, place the neutral
lock lever in the (N) NEUTRAL LOCK position and
engage the parking brake switch.
2. Raise both outriggers fully, and shut the engine OFF.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
5. Place a Do Not Operate Tag on both the ignition key
switch and the steering wheel, stating that the
machine should not be operated.
6. Disconnect the pressure switch wiring connector (1)
from the harness connector (2).
7. Remove the outrigger pressure switch (3) from the
outrigger cylinder.
8. Wipe up any spilled hydraulic oil.
b. Installation
1. Install the pressure switch (3), and torque to 25-38
lb-ft (34-41 Nm).
2. Connect the pressure switch wiring connector (1) to
the harness connector (2).
3. Properly connect the battery.
4. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
5. Close and secure the rear door.
9.11 DISPLAY MONITOR AND GAUGES
9.11.1 Instrument Cluster
a. Instrument Cluster Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the transmission control lever in
(N) NEUTRAL, engage the park brake and shut the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and the steering wheel, stating that the
machine should not be operated.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
5. Remove the right access panel.
6. Unscrew the locking ring from below the instrument
cluster (4). Pull the instrument cluster up and away
from the cut-out, and unplug the harness connector.
b. Instrument Cluster Bulb Removal
1. Remove the instrument cluster from the cab. Refer
to Section 9.11.1, a. “Instrument Cluster Removal.”
2. Remove the instrument cluster rear cover plate.
3. Rotate the bulb assembly 1/4 turn counterclockwise
and remove bulb.
c. Instrument Cluster Installation and Testing
1. Connect the harness connector to the instrument
cluster terminal.
2. Place the instrument cluster into the cut-out, and
install the plastic retaining ring and secure.
3. Install the right access panel.
4. Properly connect the battery.
5. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
6. Turn the ignition to the RUN position. All lights must
illuminate for 3 seconds.
7. Close and secure the rear door.
MAQ0250
1
2
3
MAQ0260
4