SkyTrak 6036 Service Manual - Manual (Page 90)

Boom
3-48 6036, 6042, 8042, 10042, 10054
3.8 QUICK ATTACH ASSEMBLY
3.8.1 Quick Attach Removal
1. Remove the lock bolt holding the Attachment Tilt
cylinder rod end pin to the quick attach assembly.
Remove the Attachment Tilt Cylinder pin.
2. Support the quick attach assembly. Remove the
capscrew and locknut securing the quick attach pivot
pin to the quick attach assembly. Remove the quick
attach assembly. Record the location and quantity of
the shim washers as the pin is being removed.
3. Inspect the above pins for nicks or surface corrosion.
Use fine emery cloth to fix minor nicks or corrosion.
If damaged or if it cannot be repaired the pin must be
replaced.
3.8.2 Quick Attach Installation
1. Assemble the quick attach to the boom head. Line
up the quick attach between the mounts on the
boom head. The quick attach should be centered in
the boom head. Reassemble the shims between the
quick attach and the boom head.
2. Coat the quick attach head pin with an anti-seize
compound. Insert the quick attach head pin through
the quick attach and boom head. Secure with the
previous capscrew and locknut.
3. Align the quick attach with the Attachment Tilt
cylinder rod end and insert the Attachment Tilt
cylinder pin. Align the Attachment Tilt cylinder pin
and screw in the locking bolt. Torque as required.
3.9 BOOM WEAR PADS
The wear pads on this machine are flat rectangular wear
pads with metal inserts.
A total of 32 wear pads are installed on the boom sections
of the 6036, 6024, 8042 & 10042 machines and 47 wear
pads on the 10054 machines.
3.9.1 Wear Pad Inspection
Inspect all wear pads for wear. If the angle indicators (1)
on the ends of the wear pads are visible, the wear pads
can be reused. If the pads show uneven wear (front to
back), they should be replaced. Replace pads as a set if
worn or damaged.
3.9.2 Wear Pad Installation and Lubrication
Note: Inspect all wear pads. Replace as necessary.
The following wear pad procedure must be followed to
insure the proper wear pad installation:
• The wear pad inserts and mounting bolts MUST be
clean from any grease, oil or other contaminates
before applying Loctite
® 242 TM and installing
mounting bolts.
• Apply Loctite ® 242 TM to all wear pad mounting bolts.
• A spacer (2) must be used before any shim (3) is
used.
• A shim (3) must be inserted between the spacer (2)
and wear pad support plate, block or boom section
(4).
• The number of shims can vary at each shim point.
• The bottom wear pads must be shimmed equally on
each side.
1 1
MAQ0420
4
3
2