Installation of roof panels – Mueller Pre-Fab User Manual
Page 59
www.muellerinc.com
E-13
InsTallaTIon of Roof Panels
With the first panel run installed and secured, and sidelap sealant applied, the second panel run
may be started . Prepare the eave with an inside closure and sealant tape as shown previously .
Position the panel so the overlapping ribs will nest properly . Be sure to check for proper overhang
and panel coverage . Lap screw the major ribs of the two panels together, and fasten panel to
the purlins .
Wall Panel
Eave Flashing
Blanket
Insulation
Eave
Strut
Double-sided Tape
Inside
Closure
Sealant
Tape
noTe: If peak sheets are being used at the ridge, it is critical that the ribs on the
roof panels from both sides align.
WaRnInG! sweep up all drill shavings from panels at the end of each work
period to minimize surface rust and damage to panel finish.