Brocade Communications Systems Brocade Backbone DCX 8510-4 - Manual (Page 79)

Brocade DCX 8510-4 Backbone Hardware Reference Manual 59
53-1002177-05
Chapter
5
Removal and Replacement Procedures
In this chapter
• Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
• ESD precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
• Chassis door removal and replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
• Vertical cable management fingers removal and replacement . . . . . . . . . . 61
• Port, application, and encryption blade removal and replacement. . . . . . . 62
• Blade filler panel removal and replacement . . . . . . . . . . . . . . . . . . . . . . . . . 65
• Control processor blade (CP8) removal and replacement . . . . . . . . . . . . . . 66
• Core switch blade (CR16-4) removal and replacement . . . . . . . . . . . . . . . . 76
• Power supply removal and replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78
• Blower assembly removal and replacement . . . . . . . . . . . . . . . . . . . . . . . . . 80
• WWN card removal and replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 82
• Transceiver removal and replacement. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85
• Inter-chassis link (QSFP) cable removal and replacement . . . . . . . . . . . . . . 88
• Brocade DCX 8510-4 chassis removal and replacement . . . . . . . . . . . . . . . 94
Introduction
NOTE
Read the safety notices before servicing ( “Safety notices” ).
The field-replaceable units (FRUs) in the Brocade DCX 8510-4 can be removed and replaced
without special tools. The Brocade DCX 8510-4 can continue operating during many of the FRU
replacements if the conditions specified in the procedures are followed.
The following sections contain FRU removal and replacement procedures (RRPs).
ESD precautions
The Brocade DCX 8510-4 contains electrostatic discharge (ESD) sensitive FRUs. When working with
any Brocade DCX 8510-4 FRU, use correct ESD procedures.
• Wear a wrist grounding strap connected to chassis ground (if the Brocade DCX 8510-4 is
plugged in) or a bench ground.
• Store ESD-sensitive components in antistatic packaging.