Brocade Communications Systems Brocade Backbone DCX 8510-4 - Manual (Page 84)

64 Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-05
Port, application, and encryption blade removal and replacement
5
11. Perform the appropriate following action based on the type of blade:
• For FC8-64, FC8-32E, FC8-48E, FC16-32, FC16-48 port blades, FX8-24 application blade,
and FS8-18 encryption blade: Open the ejectors by rotating them toward the center of the
blade face. Pull the blade out of the chassis using the ejectors.
12. If the blade is not being replaced by another blade, install a filler panel.
FIGURE 20 Removal and replacement of the port, application, or encryption blades (FC16-48 port
blade shown)
Replacing a blade
For this procedure, refer to Figure 20 .
Complete this procedure to replace a blade.
ATTENTION
Follow electrostatic discharge (ESD) precautions while replacing any blade.
1. Orient the blade so that the ports are at the front of the chassis and the flat side of the blade is
on the bottom.
2. Perform the appropriate following action based on the type of blade: