Class1 3041-10X-00-CL1 - Sentry Governor - EXTERNAL - Manual (Page 32)

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
TECHNICAL DATA SHEET
PAGE
31 OF 36
DATE 6/19/2014
PRODUCT GROUP THROTTLE CONTROL P/N 3045-101-00-CL1, 3045-102-00-CL1 REV 1.02
PRODUCT SENTRY PRESSURE GOVERNOR BY AMS
7.3. Configure the Twister for operation with the Sentry (slave)
3. Press and hold the IDLE button until the ACTIVE LED blinks twice (two seconds). Continue holding the IDLE
button while entering the password.
4. [Set the Twister to Sentry mode] Use the knob to enter the password:
NOTE: A clockwise rotation will turn the ACTIVE LED ON for a half- second and a counter-clockwise rotation
will turn the THROTTLE READY LED ON for a half-second. Wait for the LED indication to turn OFF before rotating
the knob again. A rotation consists of at least one tactile click and a single rotation event is complete when the knob
remains stationary for at least half a second.
5. Press and hold the IDLE button until the ACTIVE LED blinks twice (two seconds). Continue holding the IDLE
button while entering the password.
6. [Set Twister to allow address entry] Use the knob to enter the password:
7. Release the idle button.
8. [Enter the secondary address] Use the knob to enter the password:
9. Once all 8 rotations of the desired address have been completed the Twister will flash the THROTTLE READY LED
seven times followed by a single flash of the ACTIVE.