AirLive A.DUO - Manual (Page 47)

4. Wireless and WAN Settings
AirLive A.DUO User’s Manual 40
For WDS Bridge mode, the Site Survey will scan for available AP and Bridge
networks. User can then find the MAC address (BSSID) of the remote
Bridges.
For AP and AP router mode, the Site Survey allows administrator to check
what channels are already occupied for choosing a cleaner channel.
When you click on Site Survey, the following screen will appear. It might take a few minutes
to scan all the channels in the 5GHz spectrum.
Associate: Please choose a SSID before click on this button. This button is available
only in Client Infrastructure or Bridge Infrastructure modes. Once you click on this
button, A.DUO will attempt to make a connection with the selected ESSID. If there is
encryption needed, the A.DUO will prompt you to enter the encryption key. Please
make sure you enter the correct encryption key, the A.DUO will not check whether the
encryption key is correct.
RSSI: RSSI is a value to show the Receiver Sensitivity of the A.DUO. In general,
remote APs with stronger signal will display higher RSSI values. For RSSI value, the
smaller the absolute value is, the stronger the signal. For example, “-50db” has
stronger signal than “-80dB”. For outdoor connection, signal stronger than -60dB is
considered as a good connection.
Click here to select
SSID for Association
or Signal Survey
For antenna alignment,
it will display and
update RSSI value
once a second To connect with the selected
SSID, this function is available
only in Client Infrastructure or
Bridge Infrastructure