AirLive A.DUO - Manual (Page 72)

4. Wireless and WAN Settings
65 AirLive A.DUO User’s Manual
Enable Bandwidth: Check to enable Bandwidth Control. Uncheck to disable it. The default
value is disabled.
You must select between Total Bandwidth and Per-User Bandwidth. They can not be
enabled at the same time.
Total Bandwidth: Total Bandwidth control limit the bandwidth between
Wireless and Ethernet interface. Therefore, it is most suitable for Client
Infrastructure Mode, Bridge Mode, and WISP Router Mode. For WISP
operator who use A.DUO as the client side device; setting the Total
Bandwidth control on the A.DUO will easy the loading on the AP for
bandwidth management. To begin, please enable the Bandwidth
Management first. Then enter the downlink and uplink speed; click on Apply
to finish.
Check to
enable
Bandwidth
Control
Select Total
or Per User
control here
After enabling Bandwidth
Control and selecting
“Total” or “Per User” type,
click here to Apply
Settings for Total
Bandwidth Control
Settings for Per-User
Bandwidth Control