AirLive A.DUO - Manual (Page 73)

4. Wireless and WAN Settings
AirLive A.DUO User’s Manual 66
Total Downlink Speed: Enter speed you wish to limit the download traffic
in Kbps units.
Total Uplink Speed: Enter the speed you wish to limit the upload traffic in
Kbps units.
Per User Bandwidth Control: Per user Bandwidth Control can limit speed of individual PC
and network device. The A.DUO allows multiple Per-User bandwidth rules and can limit the
bandwidth by IP address, MAC address, or IP segment. Please first enable the Bandwidth
Control, then select “Per User Bandwidth Control” to begin. It is recommended to use this
type of bandwidth control for Access Point and AP Router mode.
Per User Control Options
Description: Enter a description for the bandwidth policy. For example,
“VIP” subscriber
Type: A.DUO offers 3 types of Per-User Control
IP Address: To limit the bandwidth of one single IP address.
IP Segment: To limit the bandwidth the entire IP segment.
For example; if you enter the address of 192.168.1.20 with subnet mask of
255.255.255.248, the A.DUO will limit bandwidth of IP addresses from 192.168.1.17 to
192.168.1.22. Please use an online IP calculate if you are not familiar with IP segment
calculation. Below is an example link:
HU
http://www.subnet-calculator.com/
U
Because the Ethernet interface is also controlled by the Bandwidth Manager, it is
recommended that devices on the Ethernet side to use a wider IP subnet mask that will
cover the IP range of the controlled IP segment. Therefore, the devices on Ethernet
interface will not be limited by bandwidth control and still can communicate with the IP
segment. For example, if your IP segment is set to 192.168.1.20 / 255.255.255.248, then
the devices on the Ethernet side should be 192.168.1.X / 255.255.255.0.
MAC address: To limit the bandwidth of one single MAC address
Port Range: This is available only in WISP router and AP Router
mode. It can limit the bandwidth by application ports.