AirLive WN-200HD User Manual
Page 52
4. Monitor the Image Section
47
AirLive WN-200HD User’s Manual
To use this service, just follow four steps below:
(1) Enable DIPS function of the device
(2) Check your Device ID from this page. This is a unique number for each
device.
(3) If your device is behind a NAT router, please configure your device properly.
You could refer to section “Install the Camera behind a NAT Router” above.
You only need to do this job one time.
(4) Visiting our company’s web site, you can find DIPS service page as below:
Enter your Device Number and press “OK” button.
Then, a new web page will pop up and link to your device accordingly.
You will see that DIPS is a much easier service than DDNS.
Device Title:
You can enter the name of this unit here. It’s very useful to identify the specific
device from multiple units. The information will be shown on IPWizard II once
the device is found.
Software Version:
This information shows the software version of the device.
Network LED:
To turn on or off Network LED.
Power LED (Wireless LED):
To turn on or off Power LED (wireless LED if WLAN model).