AirLive WN-200HD - Manual (Page 77)

5. Troubleshooting & FAQ
AirLive WN-200HD User’s Manual 72
5
5.
Troubleshooting &
FAQ
5.1 Monitor the Image Section
Question Answer or Resolution
Features
The video and audio
codec is adopted in the
device.
The device utilizes H.264, MPEG4 and JPEG triple
compression to providing high quality images. Where
H.264 and MPEG4 are standards for video compression
and JPEG is a standard for image compression.
The audio codec is defined as AMR for 3GPP and
G.711/G.726 for RTSP streaming.
The maximum number
of users access the
device simultaneously.
The maximum number of users is limited to 20. However,
it also depends on the total bandwidth accessed to this
device from clients. The maximum data throughput of the
device is around 20~25Mbps for UDP mode and 10Mbps
for HTTP mode. Therefore, the actual number of
connected clients is varying by streaming mode, settings
of resolution, codec type, frame rate and bandwidth.
Obviously, the performance of the each connected client
will slow down when many users are logged on.
The device can be
used outdoors or not.
The device is not weatherproof. It needs to be equipped
with a weatherproof case for outdoors using. However,
equipped with a weatherproof case might disable the
audio function of the device.
Install this device
Status LED does not
light up.
• Check and confirm that the DC power adaptor, included
in packaged, is used. Secure the power connector and
re-power it on again.
• If the problem is not solved, the device might be faulty.
Contact your dealer for further help.
The network cabling is
required for the device.
The device uses Category 5 UTP cable allowing 10
and/or 100 Base-T networking.
The device will be If a firewall exists on the network, port 80 is open for