AirLive WN-200HD - Manual (Page 56)

4. Monitor the Image Section
51
AirLive WN-200HD User’s Manual
5. Once the firmware file was selected, click “Firmware Upgrade”
button.
6. The upgrade progress information will be displayed. Once the uploading
process completed, the device will reboot the system automatically.
7. Please wait for timer countdown, and then you can use IPWizard II to search
the device again.
Warning!!! The download firmware procedure cannot be interrupted. If
the power and/or network connection are broken during the download
procedure, it might possibly cause serious damage to the device.
Strongly suggest that DO NOT upgrade firmware via Wireless LAN due to
high error rate possibly and don't allow any other clients to access this
unit during updating procedure.
Be aware that you should not turn off the power during updating the
firmware and wait for finish message.
Furthermore, the firmware upgrade procedure always is risk and do not
try to upgrade new firmware if it’s not necessary.
System Restart:
The device is restarted without changing any of the network settings. It means
the IP address of the device will not change after firmware upgrade.
4.5 Video – Configure Profile
This device provides 2 modes of video profile. The first one is Mega-Pixel
mode which supports video resolution up to Mega-pixel. However the
maximum frame rate of this mode is up to 15fps only. The second one is VGA
mode which supports video resolution up to VGA but frame rate can be up to
30fps. User only can select either Mega-pixel or VGA mode to operate the
camera. Switching Mega-pixel and VGA, the device will take time to reboot
system.