AirLive WN-200HD - Manual (Page 83)

5. Troubleshooting & FAQ
AirLive WN-200HD User’s Manual 78
5.2 PING
The PING (stands for Packet Internet Groper) command is used to detect whether a
specific IP address is accessible by sending a packet to the specific address and
waiting for a reply. It’s also a very useful tool to confirm the device installed or if the IP
address conflicts with any other devices over the network.
If you want to make sure the IP address of the device, utilize the PING command as
follows:
z Start a DOS window.
z Type ping x.x.x.x, where x.x.x.x is the IP address of the device.
The replies, as illustrated below, will provide an explanation to the problem.
If you want to detect any other devices conflicts with the IP address of Network
Camera, also can utilize the PING command but you must disconnect the device from
the network first.