Atop Technology SE8502-M12 User Manual - Manual (Page 30)

User manual Version 1.1
SE8502-M12 IP68 Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved
26
4.2.3. SNMP Settings
Operation: [Main]Æ[2 Networking]Æ[3 SNMP Settings]
Select “3” from “Input choice (0~3) and enter on Networking page:” to enter SNMP Settings page. User can
enable/disable SNMP, and set network identification information on SNMP Settings page. The changes will not
become effective until SE8502-M12 is restarted
SE8502-M12 basically supports get/set SNMP parameters, these are SysName (System Name), SysLocation (System
Location) and SysContact (System Contact). These fields will response and supply basic system information from
standard SNMP query. User can set the SNMP system parameters by enter the corresponding menus and values. For
example, enter 2 for changing the SysName then enter the desired name.
Fig 37. SNMP Settings by Telnet
4.3. COM Port Configuration
User can configure serial parameters, include COM1(COM2) operation mode, port parameters, enable or disable
serial buffer’s data and packet delimiter.