Atop Technology SE8502-M12 User Manual - Manual (Page 51)

User manual Version 1.1
SE8502-M12 IP68 Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved
47
UDP mode
3． COM port property: it mainly represents the working parameter of the serial port setting, including:
serial-port working type, baud rate, data bit, stop bit, parity bit, data packet delimiter and flow control,
etc.
B3.4.3 Locate
The user can apply this function to locate a device when he knows it’s IP address, but doesn’t know its
position. If a device is selected, the device will appear with singing by which the user can locate
the device
through the submenu option Locate or clicking the Locate button on the toolbar.
B3.4.4 Reset
The device should be restarted after a successful modification of parameter configuration. And the user can
carry out a restart through the submenu option Reset.
B3.4.5 Erase Flash
Some devices are supplied to the user with a certain capacity of Flash memory to save the user's data. And
the user can erase the Flash through the submenu option Erase Flash or clicking the Erase Flash button
on the toolbar when the memory capacity is to be used up or the history data are unnecessary to be saved.
B3.4.6 Import Setting …
If a network has a large number of devices which are used for a same purpose, it would be very
complicated to carry out the parameter configuration for each of the devices in the network one by one,
while the user can import the parameter information of a standard parameter file directly into all the devices
of the network through the submenu option Import setting … or clicking the Import setting … button on
the toolbar, thus the work procedures can be largely reduced, shown as the figure below: