Atop Technology SE8502-M12 User Manual - Manual (Page 33)

User manual Version 1.1
SE8502-M12 IP68 Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved
29
Operation: [Main] Æ [4 Serial Settings] Æ [1 Link mode] Æ [3 UDP]
SE8502-M12 can be configured to work in UDP mode to establish connection using Unicast or Multicast protocol.
Data can be transmitted from one or multiple serial devices to/from one or multiple host PCs and vice versa. For
example, the original RS-422/ RS485 bus data is transferred over the extended connected distance by SE8502-M12s,
The destination IP is assigned by single IP or group IPs, The configuration is limited by the Local Listening Port,
default 4660 and 4661 on the COM1 and COM2 of SE8502-M12.
SE8502-M12 can support up to 8-group IPs for UDP connection, if users needed.
Fig 42. UDP mode in link mode
” Note: In this phase, UDP mode does not support Virtual COM mode.
4.3.4. Serial Settings
Operation:
[Main] Æ [4 Serial Settings] Æ [2 Baud rate]/ [3 Parity]/[4 Data bits]/ [5 Stop bits]/ [6 Flow control]
User can configure baud rate、data bits, parity、stop bit and type of flow control.