Auto Meter 6002 - Manual (Page 22)

Chapter 4. Configuring the Display System
16 Street Dash Users Guide
Chapter 4. Configuring the Display
System
Configuration Mode
You put the Display System into configuration mode by pressing
Switches 1 and 2 together. This should give a display similar to
the following:
You then work through the configurable parameters in a preset
sequence.
Press Switch 3 to display the next configurable parameter.
Press Switch 4 to exit configuration mode.
Setting or resetting configuration values
Use Switch 1 to decrease the value being configured and Switch
2 to increase it. The rate at which the value increases or
decreases itself increases while the switch is being held down.