Auto Meter 6002 User Manual
Page 35
Chapter 5. Installing the Display System
Street Dash Users Guide
29
Connecting the Display System to the
Ignition System
The Display System can be connected to engines with a variety
of ignition systems. Please see below.
* WARNING
Warranty will be void if connected to coil when using an
aftermarket ignition box such as, but not limited to products
from the following manufacturers: MSD, Crane, Jacobs,
Mallory, Holley, Etc.. Prior to installation, check with the
ignition box manufacturer for recommended tachometer
signal loaction.
See
autometer.com/tech_installation.aspx
for specific vehicle
information.
The following connections are shown in greater detail:
•
Series Resistor Connection
•
ECU Connection (+ Pull-up resistor)
The connection of the Display System to these types of ignition
system is described on the next page: