Fuel tank sender – Auto Meter 6002 User Manual
Page 41
Chapter 5. Installing the Display System
Street Dash Users Guide
35
VSS Pulse Amplifier Technical Specification
Supply :
From system input
Output characteristics :
compatible with system
Input impedance :
>50K Ohms
Operating temperature range :
-4 to 176 ºF
Input threshold adjustment range :
-5 Volts to +12 Volts
Input hysteresis :
+/- 0.1 Volt
Maximum input frequency
2000 Hertz
Physical dimensions :
(mm) L 51, H 18, W 32
(in) L 2, H ¾, W 1¼
Weight :
50g / 2oz maximum
Vibration testing :
20 G, 50Hz to 2000Hz,
1 Octave/min for 12 hours
Fuel Tank Sender
Plug the adapter supplied in the sensor bag to the 4-way sure seal
connector marked F.
Single-Wire Sender
If your vehicle is fitted with a single-wire sender (rheostat),
remove the existing wire from it and connect the red (F) wire to
it.
Two-Wire Sender
If your vehicle is fitted with a two-wire sender (potentiometer),
remove the existing wires and fit the red (F) wire to one of the
terminals. If there is no change in fuel-level reading during
calibration, fit the red wire to the other terminal.
In some cases, it may be necessary to attach a grounded wire to
your fuel sender mounting flange for proper operation.