Auto Meter 6002 - Manual (Page 34)

Chapter 5. Installing the Display System
28 Street Dash Users Guide
Warning Lights
The Display Module has two built-in warning lights. The left-
hand (amber) light is the fuel level warning light and the right-
hand (red) light alerts the driver whenever an alarm has been
triggered.
As an option, you can install additional external warning lights
for gear shift and alarm warnings. The external warning lights
should be installed in any position that is in the driver’s direct
line of vision, as they need to be visible at all times.
If you are using your own warning lights, ensure that
the bulb rating does not exceed 2 Watts; otherwise the
Display Module will be damaged. If you need to use
lamps greater than 2W, connect them to relays and use
the output sockets from the Display Module to switch
these relays.
Shift Light
Auto Meter offers a direct plug-in shift light (model no. 9580)
for use with this system.
Engine Speed (RPM) Measurement
The engine speed (RPM) is measured by connecting the engine
speed wire directly to the ignition system. A single wire, with the
label ES, connects the Display System to the ignition system or
low-tension negative side of the coil (see warning on the next
page).