Auto Meter 6002 - Manual (Page 37)

Chapter 5. Installing the Display System
Street Dash Users Guide 31
Pressure Sensors
Fitting the pressure sensors
The system is supplied with one pressure sensor for Oil Pressure.
This sensor has a 1/8” NPTF thread.
Installing the pressure sensors
•
Position each sensor and its cable as far as possible from all
sources of intense heat and from the ignition HT leads.
•
The sensors can be either screwed in directly to the
monitoring point or fitted separately by using suitable
pressure hose to connect them to the monitoring point. By
fitting the sensors separately, you will reduce the amount of
vibration to which they are subjected and thereby extend
their life.
•
Do not over-tighten the sensors.
•
The Fuel Pressure sensor must be connected to the A
connector on the harness. A 55” extender cable is supplied
if the standard harness is too short.
Temperature Sensors
The Display System is supplied with two temperature sensors:
The temperature sensor has two terminals and a
1/8" NPTF thread
Each sensor can be used for monitoring both oil
temperature and water temperature.
Fitting the temperature sensors
Mount each temperature sensor directly in the appropriate fluid
line. Screw the sensor into a suitable mounting boss, so that its
end lies in the middle of the flow of fluid (when applicable).
• Position the sensors and their cables as far as possible from
sources of intense heat and from the ignition HT leads.