Autoquip FREIGHTLIFT FL4M - Manual (Page 3)

3
CODE REQUIREMENTS
VRCs are NOT elevators. This lift is designed for the transfer of material only from one
level to another. Absolutely NO RIDERS! VRCs have their own national safety code
(ANSI/ASME B20.1) and are specifically exempt from the National Elevator Code.
Some states require special components and have specific guidelines regarding how
the equipment must be installed, inspected, and tested. The owner is ultimately
responsible for understanding these requirements for the specific job location, and
Autoquip will incorporate any special requirements into the order as requested and
approved by the customer.
Call Autoquip Corporation at (405) 282-5200 or 1-888-811-9876 with any questions
you may have concerning VRC code requirements.
IMPORTANT
Autoquip Corporation has designed and manufactured the FREIGHTLIFT to safely and
efficiently move materials between multiple floors or levels. It has been built to provide
many years of dependable service.
INSTALLERS - Proper installation of this equipment is vital to both the efficiency of the
unit and the ultimate satisfaction of the end user. It is vital for the installers to read
and understand this manual! These instructions have been prepared and organized
to assist the installers and it is important for these individuals to carefully follow the
steps in the order they are presented!
OPERATORS - Please read and understand this manual prior to operation of this
Freightlift. Failure to do so could lead to property damage and/or serious personal
injury.
Situations may arise which are not covered in this manual. If you have questions,
please call Autoquip Customer Service at (405) 282-5200 or 1-888-811-9876.
NOTE: Unless otherwise stated, mechanical installation does not include
unloading, permits, seismic calculations, or extensive acceptance testing. The
requirements of each contract should be carefully reviewed for possible conflicts
of interpretation.
PLANNED MAINTENANCE PROGRAM
A local Autoquip representative provides a Planned Maintenance Program (PMP) for
this equipment using qualified and experienced personnel. Call a local representative
or Autoquip Corporation at 1-888-811-9876 or 405-282-5200 for more information.
INTRODUCTION