Installation, Instructions – Autoquip FREIGHTLIFT FL4M User Manual
Page 47
47
F. DRIVE BASE INSTALLATION DETAILS (Reference Figures 26 through 28)
Items needed:
Qty
Description
1
Drive Base w/Gearmotor, Shaft, Bearings & Sprockets
2
Front-to-Drive Base Channels (4”)
2
Back-to-Drive-Base Channels (4”)
varies
1/2" x 2”, Grade 8 Hex Head Cap Screw, Washer, and Nuts
4
1/2" x 5”, Grade 8 Hex Head Cap Screws
1. Raise the drive base into position above the mast beams in the orientation shown in
Figure 26 and bolt into place using the 1/2" x 5” long hex head cap screws provided.
Torque to 99 ft-lbs.
2. Bolt the (2) Front-to-Drive-Base channels and (2) Back-to-Drive-Base Channels into
place as shown in Figures 27 and 28 using the high grade 1/2" x 2” lg. bolts, lock
washers, and nuts provided. Torque to 99 ft. lbs.
INSTALLATION
INSTRUCTIONS