Autoquip FREIGHTLIFT FL4M - Manual (Page 4)

4
Your FREIGHTLIFT arrives packaged as follows: The four (4) masts and platform
(either 1-piece or 2-piece if spliced) come on shipping skid(s), you also receive parts
crate(s) which normally contain the following items:
A. 48” H Side Guards/Handrails (Qty depends on platform size & layout)
B. Six or more - 6” Intermediate Channels
C. Two Front & Two Back - 6” Channels, Drive Base to Cross Channel
D. (1) Back & (1) Front – 6” Mast Cross Channels; (2) 6” Drive Base
Channels
E. One Steel Tube Drive Base with Gear Motor, Shaft & Bearings
F. Upper Level floor Brace Assemblies, includes brace plates & channels
G. Two Installation Angles (with holes on each end)
H. (4) equal lengths of Drive Chain; (4) equal lengths of Lifting Chain
(usually longer than drive chain)
I. Four Wheel Guide Assemblies with Locking Cams
J. Four Counterweights & Lifting Chain Kit with Chain Adaptors, Pins, etc
K. (2) Counterweight Sensing Switch Kit; (4) Slack Chain Sensing Switch
Kits (for lifting chains), and Level/Over-travel Limit Switch Kits
(quantity depends on number of levels)
L. Miscellaneous hardware, manuals, signs, extra structural supports etc.
(depends on order – consult Packing List)
NOTE: The “Bill of Lading” will state the number of pieces shipped. TWO ITEMS
MAY BE BANDED TOGETHER AND COUNT AS ONE PIECE.
Upon receipt of the shipment, check for exposed damage or shortages and make note
of it on the trucking company Bill of Lading or the Shipping Papers. Reports of
concealed damage to items contained in crates must be reported within 48 hours. DO
NOT destroy the crating while opening it to inspect the contents. If damage is
suspected or found, report it directly to the carrier. DO NOT contact Autoquip
Corporation!! All shipments are FOB from the Autoquip plant. Any claims for damage
must be filed with the carrier. Any parts shipped from Autoquip that are intended
to replace damaged or lost items will be invoiced to the ordering party.
Assuming no damage has occurred to the crate(s), check the components against the
packing list. This will provide assurance that every item shipped has been received,
report any shortages to Autoquip Corporation within 10 days. (Autoquip is not
responsible for parts lost, stolen or damaged during transportation, storage, installation,
or during any other circumstances that may be beyond Autoquip’s control.)
INSPECTION & IDENTIFICATION