DATOptic ARC-1680 Series - Manual (Page 73)

BIOS CONFIGURATION
73
Choose this option from the main menu to select a physical disk
and perform the operations listed above. Move the cursor bar to
an item, then press Enter key to select the desired function.
3.7.4.1 View Drive Information
When you choose this option, the physical disks connected to
the SAS RAID controller are listed. Move the cursor to the de-
sired drive and press Enter key to view drive information.
I/O Port Addr : 28000000h, F2(Tab): Select Controller, F10: Reboot System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
Areca Technology Corporation RAID Controller
Main Menu
Quick Volume/Raid Setup
Raid Set Function
Volume Set Function
Physical Drives
Raid System Function
Hdd Power Management
Ethernet Configuration
View System Events
Clear Event Buffer
Hardware Monitor
System information
Physical Drive Information
Select The Drives
E#1Solt#2 : 500.1GB : HDS725050KLA360
E#1Solt#3 : 500.1GB : ST3500630NS
E#1Solt#4 : 400.1GB : Hitachi HDT725040VLA360
E#1Solt#5 : 400.1GB : Hitachi HDT725040VLA360
E#1Solt#6 : 400.1GB : Hitachi HDT725040VLA360
E#1Solt#7 : 500.1GB : HDS725050KL360
E#1Solt#8 : 500.1GB : ST3500630NS
E#1Solt#2 : 500.1GB : HDS725050KLA360
Ch01
Model Name : ST380013AS
Serial Number : 5JV944ZF
Firmware Rev. : 3.18
Disk Capacity : 80.0 GB
PIO Mode : Mode 4
Current UDMA : SATA150(6)
Supported UDMA : SATA150(6)
Device State : RaidSet Member
Timeout Count : 0
Media Errors : 0
SMART Read Error Rate : 200 (51)
SMART Spinup Time : 173 (21)
SMART Reallocation Count : 200 (140)
SMART Seek Error Rate : 200 (51)
SMART Spinup Retries : 100 (51)
SMART Calibration Retries : 100 (51)
3.7.4.2 Create Pass-Through Disk
A pass-through disk is not controlled by the SAS RAID controller
firmware and thus cannot be a part of a volume set. The disk is
available directly to the operating system as an individual disk.
It is typically used on a system where the operating system is
on a disk not controlled by the SAS RAID controller firmware.
The SCSI Channel/SCSI ID/SCSI LUN, Cache Mode, and Tag
Queuing must be specified to create a pass-through disk.