Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 10)

EXM UHP– Installation Instructions
(Step 2 – Configure the System)
10
Installation Step 2: Configure the EXM System
Obtaining the EXM Configuration Tool –
To obtain the latest EXM Configuration Tool go to
www.elkhartbrass.com . Starting from the homepage, go to
the Downloads drop down menu and select Product Aids. On the Product Aids page scroll down the page to the
Monitors section and find the EXM Configuration Tool. Download and install this program to your computer.
EXM System Groups –
When configuring a custom EXM system, only one group may be configured at a time. A group is one
complete EXM system containing at least 1 monitor and 1 input controller. A group may contain multiple input
controllers, 1 Valve, and 1 Position Indicator Display. If installing multiple EXM groups onto a single CAN
line, the groups must be numbered and configured with their respective group number.
EXM Valves –
If two EXM groups both containing valves are to be installed onto the same CAN line, only the valve being
configured should be connected to the CAN line. Any other valves, not in the EXM group being configured,
must be disconnected from the CAN line. When the second EXM group is to be configured, disconnect the
valve in the first group and connect the valve in the second.
Configuration Steps –
(Continue on to Steps 3 and 4 on the following page)
After installation, run the Configuration
program by double-clicking on the
desktop icon shown to the left. You
will see the splash screen below when
the program is loading.
When the Configuration Tool starts you will see the
screen shown above.
The settings chosen during this process will act as the
default settings of the monitor. These settings are
what the monitor will convert back to when the Clear
All function is entered with one of the input
controllers.
1 2