Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 19)

EXM UHP– Operating Instructions
19
F. Stow Position
The Stow Position is a preset position that can be used to bring the monitor into a position suitable for when the
system is powered off. A stow position must be within the allowed travel area defined by any travel limits or
keep out zones.
 Put the EXM system into Setup Mode (reference Part B of the Operating Instructions section)
 Move the monitor to the desired position
 The Stow Position should be within the previously set monitor rotation limits. If Stow Position is set
outside the intended operating area, operation of the Stow command may be unpredictable.
 Press the FOG and OSCILLATE buttons at the same time (rotate thumbwheel down for FOG on Joystick)
 This position will be the Stow Position when the system is brought out of Setup Mode
 Simply press and hold the FOG and OSCILLATE buttons for three seconds to put the monitor into the
Stow Position while outside of Setup Mode (rotate thumbwheel down for FOG on Joystick)
Warning:
Water should not be flowing while using the Stow Position command.
G. Motor Speed
The speed of both the horizontal and vertical motors can be changed from something different than that set
during configuration of the EXM system. The monitor’s horizontal and vertical motors can be set to either Fast
or Slow in one of four combinations.
 Put the EXM system into the Setup Mode (reference Part B of the Operating Instructions section)
 Press the OSCILLATE button to cycle through the various motor speed combinations
o The horizontal, vertical, and nozzle LED’s on the monitor are used to show which motor speed
combination the monitor will be set at after Setup Mode is exited
o All Yellow LED’s “OFF” places both motors in fast mode
All Yellow LED’s “ON” places both motors in slow mode
One Yellow LED only “ON” indicates horizontal motor fast and vertical motor slow mode
Two Yellow LED’s only “ON” indicates horizontal motor slow and vertical motor fast mode
 When the system is brought out of Setup Mode, the motor speeds will be changed to the combination
selected