Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 20)

EXM UHP– Operating Instructions
20
H. Clear All Function
The Clear All Function allows the user to remove any Travel Limits, Keep-Out Zones, or Stow Positions set
while in Setup Mode. When the Clear All Function is used, it will remove all of the previously listed
operations. The Clear All Function will not affect calibration points, Motor Speed, or Preset valve positions.
 Put the EXM system into Setup Mode (reference Part B of the Operating Instructions section)
 Press the OPEN and CLOSE buttons simultaneously
 All set Travel Limits, Keep-Out Zones, and Stow Positions will be removed from the system
I. Oscillation
The oscillation function is used to move the monitor back and forth inside a boxed area or straight horizontal or
vertical line specified by the user.
 Move the monitor to one corner of the intended boxed area (For a straight horizontal or vertical line,
move monitor to the first line endpoint.)
 Press the OSCILLATE button
 Move the monitor to the opposite corner of the intended boxed area (For a straight horizontal or vertical
line, move monitor to the opposite endpoint of the line.)
 Press the OSCILALTE button a second time
 The monitor should begin moving up and down, and left and right within the boxed area. (If setting a
horizontal or vertical line, monitor should begin oscillating horizontally or vertically only.)
 If there is no monitor movement for 30 seconds while setting up the oscillation limits, the monitor will
automatically exit oscillate setup
 Pressing UP, DOWN, LEFT, RIGHT, or OSCILLATE will stop oscillation of a boxed area (Pressing
LEFT, RIGHT, or OSCILLATE will stop horizontal oscillation while pressing UP, DOWN, or
OSCILLATE will stop vertical oscillation.
o All other functions can be operated without stopping oscillation.
J. Auxiliary
 Turn on/off optional light 1 – Press AUX and FOG simultaneously
 Turn on/off optional light 2 – Press AUX and STREAM simultaneously