Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 8)

EXM UHP– Installation Instructions
(Step 1 – Mount and Wire All System Components)
8
B. Joystick Controller and OEM Interface Module –
 Using the template shown on page 28, drill
all holes shown onto the surface intended for
mounting the Joystick Controller.
 Mount the Joystick Controller using the
supplied 10-24 x ½” screws using blue
Loctite 242 or equivalent.
 Using the template shown on page 27, drill
all 4 of the 7/32” holes shown.
 Mount the OEM Interface Module with four
10-24 x ½” screws using blue Loctite 242 or
equivalent.
 Connect the plug coming from the Joystick
Controller stick to plug 2 on the OEM
Interface Module. (See picture to the right)
 If the Joystick/OEM will use CAN
communication, connect the green, black,
and blue leads coming from plug 1 to the
appropriate CAN line. (See picture below)
 Supply power to the OEM Interface Module
and Joystick by connecting the red and black
leads coming from plug 1 to an appropriate
power source. (See picture on previous
page)
 Install a 1 Amp fuse into the positive power
lead of the OEM Interface Module for a 12V
system (1/2 Amp for 24V system).
 Refer to the respective plug figures on the
previous page for information on the plugs’
pins.
 For information regarding external switches
and customer supplied joysticks, refer to the
pin information found on the Module cover.
 If there are any unused OEM Interface
Module connections, plug the connections
with appropriate Deustch connectors and
plugs.
Joystick Plug Information
2
OEM Interface Module Plug Information
1
2
1
Valve Plug