Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 13)

EXM UHP– Installation Instructions
(Step 2 – Configure the System)
13
10
Go to the Save Settings tab to save the configuration file to a
USB flash drive. Simply click ‘Browse’ and select the drive
location. Click the ‘Save to USB’ button and a popup
message will appear confirming that the configuration file
has been saved. To ensure that the configuration file will
properly configure the EXM system, use a blank USB.
The checkboxes on the left side of this tab allow you to
choose whether you will configure you system’s Monitor,
Input Controllers and Valve, or Position Display. If this is
your first time configuring your system, you will likely need
to check all boxes.
The box labeled Group Number allows you to change the
EXM group being configured. This number changes
automatically based on monitor type and only needs to be
changed if multiple monitors of the same type are being used
on the same CAN line (i.e. Sidewinder with Sidewinder).
Click the Exit tab to close the program when finished.
After the configuration file for your system has been successfully saved to a USB flash drive, ensure that all CAN
components are connected and power up all components within the EXM system. (To power on a Handheld
Controller that is hibernating, press and release the AUX button)