Connecting motor power – ElmoMC SimplIQ Digital Servo Drives-Bell Installation Guide User Manual
Page 22
Bell Installation Guide
Installation
MAN-BELIG (Ver. 1.302
22
3.7.1.
Connecting Motor Power
Connect the M1, M2, M3, M4 and PE pins on the Bell in the manner described in Section 3.5
(Integrating the Bell on a PCB). The phase connection is arbitrary as the Composer will establish
the proper commutation automatically during setup. However, if you plan to copy the setup to
other drives, then the phase order on all copy drives must be the same.
Note:
The Bell is equipped with four motor wires.
For DC motors, connect only M1 and M2.
For 3-phase motors, connect M1, M2 and M3.
For steppers and 2-phase motors, connect M1, M2 to one coil and M3, M4 to the other
coil.
Leave unused motor wires disconnected.
Figure 4: AC Motor Power Connection Diagram