ElmoMC SimplIQ Digital Servo Drives-Bell Installation Guide - Manual (Page 9)

Bell Installation Guide Safety Information
MAN-BELIG Ver. 1.302
9
1.3. Directives and Standards
The Bell conforms to the following industry safety standards:
Safety Standard Item
Approved IEC/EN 61800-5-1, Safety Adjustable speed electrical power drive systems
Recognized UL 508C Power Conversion Equipment
In compliance with UL 840 Insulation Coordination Including Clearances and
Creepage Distances for Electrical Equipment
In compliance with UL 60950-1
(formerly UL 1950)
Safety of Information Technology Equipment Including
Electrical Business Equipment
In compliance with EN 60204-1 Low Voltage Directive 73/23/EEC
The Bell stepper drive has been developed, produced, tested and documented in accordance with
the relevant standards. Elmo Motion Control and Digital Feedback Technologies are not
responsible for any deviation from the configuration and installation described in this
documentation. Furthermore, they are not responsible for the performance of new
measurements or ensuring that regulatory requirements are met.