ElmoMC SimplIQ Digital Servo Drives-Bell Installation Guide - Manual (Page 7)

Bell Installation Guide Safety Information
MAN-BELIG Ver. 1.302
7
Chapter 1: Safety Information
In order to achieve the optimum, safe operation of the Bell stepper drive, it is imperative that you
implement the safety procedures included in this installation guide. This information is provided
to protect you and to keep your work area safe when operating the Bell and accompanying
equipment.
Please read this chapter carefully before the installation process.
Before you start, make sure that all system components are connected to earth. Electrical safety
is provided through a low-resistance earth connection.
Only qualified technical personnel may install, adjust, maintain and repair the stepper drive. Such
personnel have the knowledge and authorization to perform tasks such as transporting,
assembling, installing, commissioning and operating motors.
The Bell stepper drive contains electrostatic-sensitive components that can be damaged if
handled incorrectly. To prevent any electrostatic damage, avoid contact with highly insulating
materials, such as plastic film and synthetic fabrics. Place the product on a conductive surface and
ground yourself in order to discharge any possible build-up of static electricity.
To avoid any potential hazards that may cause severe personal injury or damage to the product
during operation, keep all covers and cabinet doors shut.
The following safety symbols are used in this manual:
Warning:
This information is needed to avoid a safety hazard, which might cause bodily
injury.
Caution:
This information is necessary for preventing damage to the product or to other
equipment.