A three-phase direct-to-mains connection topology, Figure 6 – ElmoMC ExtrIQ Digital Servo Drives-Panther User Manual
Page 31
Advertising
Panther Installation Guide
Installation
MAN-PANIG (Ver. 1.302)
31
3.7.2.1.a
Three-Phase Direct-to-Mains Connection topology
Figure 6: Non-Isolated Three-Phase Connection Topology
Caution:
Do not connect VN- to PE. In a direct-to-mains connection, the VN- must not be
connected to the PE, as this will cause irreparable damage to the system.
Take care to note that in a direct-to-mains connection the Neutral point is not
the most negative voltage level. It is the mid-point level of the rectified DC bus.
Advertising