Enerpac XLP 50 and 75 ton - Manual

1
2.0 SAFETY ISSUES
Read all instructions, warnings and cautions carefully. Follow all
safety precautions to avoid personal injury or property damage
during system operation. Enerpac cannot be responsible for damage
or injury resulting from unsafe product use, lack of maintenance or
incorrect product and/or system operation. Contact Enerpac when
in doubt as to the safety precautions and operations. If you have
never been trained on high-pressure hydraulic safety, consult your
distribution or service center for a free Enerpac Hydraulic safety
course. Failure to comply with the following cautions and warnings
could cause equipment damage and personal injury.
A CAUTION is used to indicate correct operating
or maintenance procedures and practices to
prevent damage to, or destruction of equipment or
other property.
A WARNING indicates a potential danger that requires
correct procedures or practices to avoid personal injury.
A DANGER is only used when your action or lack of
action may cause serious injury or even death.
WARNING: Wear proper personal protective gear when
operating hydraulic equipment.
WARNING: Stay clear of loads supported by hydraulics.
A cylinder, when used as a load lifting device, should
never be used as a load holding device. After the
load has been raised or lowered, it must always be
blocked mechanically.
WARNING: USE ONLY RIGID PIECES
TO HOLD LOADS. Carefully select steel
or wood blocks that are capable of
supporting the load. Never use a hydraulic
cylinder as a shim or spacer in any lifting or
pressing application.
DANGER: To avoid personal injury keep
hands and feet away from cylinder and
workpiece during operation.
XLP-Series 50 and 75 ton
Workshop Presses
Instruction Sheet
EIS 66.112-1 rev. O 05/2014
Repair Parts Sheets for this product are available from the Enerpac web site at www.enerpac.com,
or from your nearest Authorized Enerpac Service Center or Enerpac Sales office.
XLP-Series presses can be set up to perform maintenance and for-
ming operations. Each press is delivered with cylinder, hose, couplers
and pump. The XLP-Series presses include a lower bed lifting device.
Optional is the V-block workpiece support to facilitate the positioning
of pipes and bars.
GB
Index: Pages
English (GB) .................................................... 01 - 04
Français (FR) ................................................... 05 - 08
Deutsch (DE) ................................................... 09 - 12
Italiano (IT) ...................................................... 13 - 16
Español (ES) ................................................... 17 - 20
Nederlands (NL) .............................................. 21 - 24
Svenska (SE) .................................................. 25 - 28
Index: Pages
Norsk (NO) ...................................................... 29 - 32
Suomi (FI) ....................................................... 33 - 36
Polska (PL) ...................................................... 37 - 40
Czech (CZ) ...................................................... 41 - 44
Pycckий (RU) .................................................. 45 - 48
Portugues (PT) ................................................ 49 - 52
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. Shipping
damage is not covered by warranty. If shipping damage is
found, notify carrier at once. The carrier is responsible for
all repair and replacement costs resulting from damage
in shipment.
SAFETY FIRST