ETC SmartFade v3.0.1 - Manual (Page 39)

3
Program 33
Record a Magic memory
You can set up and record a random look using the Magic function.
Test memory
Press CLEAR four times to clear all intensities. Select MEMS mode. The light in the bump
button of the fader will be dimmed to show that it has content. Move the fader up. The same
look you recorded should appear on stage.
Action Console Feedback
1. Set channels or memory
faders
Faders All channel and memory faders over 0% will
be included in the Magic function. If you are
using memory faders, make sure NEXT is off.
2. Activate recording Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
3. Create a Magic look Every time MAGIC is pressed, a new random
look will be created from all channel and
memory faders over 0%.
4. If needed, change page ... If needed, hold MEMS and press a bump
button 1-12 to change page.
5. Select fader ... or
...
The moment the bump button is pressed, the
memory is stored and the console will auto-
matically return to it’s previous fader mode.
Press UNDO to undo this recording.
REC
MEM
MAGIC
MEMS 1 12
1 24
1 48