ETC SmartFade v3.0.1 - Manual (Page 51)

4
Edit 45
Edit Sequences & Stack
Sequence and Stack steps can be edited in the same way. The Stack has some extra
editing functions since there are unique Stack states and point cues, which don’t exist in
sequences. There is also a way to edit any Stack step directly, without entering the edit
menus. To delete all Sequences and the Stack See “Erase Functions” on page 23.
The functions available for modifying Sequence & Stack steps are Edit, Delete, Insert and
Change. For the stack there is also the option of recording up to 9 point Q’s between each
step.
Edit the content of a Step
A sequence or Stack step can contain a reference to a memory in a specific page, or a
single channel intensity. The Stack can have a unique Stack memory state as well.
Memories can be edited in the memory fader, or in the step. Steps that reference a single
intensity channel can not be edited, you have to use change instead to change to a different
single intensity channel. Unique Stack steps are edited as described, just like memories.
Step 1: Open the Sequences menu:
Menu>[Sequences]
Step 2: Use the wheel to select Sequence (1-24) or Stack (XF).
Press (MENU) to confirm.
Step 3: Use the wheel to select Modify Steps.
Press (MENU) to confirm.
Step 4: Use the wheel to select Step:#.
Press (MENU) to confirm.
Step 5: Use the wheel to select Edit (channels can only be changed).
Press (MENU) to confirm.
Step 6: Use the channel faders to edit the contents.
Press EDIT MEM to confirm and exit or CLEAR to abort.