Memories, Memory bump modes, Clear output from memory faders – ETC SmartFade v3.0.1 User Manual
Page 63: Select fader page
5
Playback
57
Memories
Memories are played back from the faders in MEMS mode. In each of the 12 fader pages
the buttons with memories stored will light up dimmed in red when a page is selected. When
the fader is contributing to the output, the button will light up in full.
Select Fader Page
If a fader is above zero when a different page is selected, it will not be updated to the
content of the new page until it is brought to zero. Press MEMS twice within 1 second to
select page 1 quickly.
Memory Bump Modes
The content of memory faders can be bumped to the level of the BUMPS fader in two ways.
This is controlled with the SOLO button.
•
OFF = The level generated by pressing a bump button adds into the live output.
•
ON = The level generated by pressing a bump button replaces the current output.
Clear Output from Memory Faders
Action
Console
Feedback
Select fader page
(Held)
As long as the button is held, the current fader
page is indicated with a lit bump 1-12. Bumps
for pages with recorded information will blink.
To select a new page, press bump 1-12 and
let go of the MEMS button.
Action
Console
Feedback
Clear output from Memory
Faders
and
All memory faders will be set to zero.
MEMS
SOLO
CLEAR
MEMS