Tap mode for the stack, N o t e – ETC SmartFade v3.0.1 User Manual
Page 68
62
SmartFade v3.0.1 User Manual
Tap Mode for the Stack
Tap Mode allows the recording of actual elapsed time for each step of the Stack by means of
the GO button. It should set to OFF at all times unless a timed recording is being made.
Step 1:
First record a Stack in the normal way
Step 2:
Open the Sequences menu:
Menu>[Sequences]
Step 3:
Use the wheel to select the Stack (XF).
Press (MENU) to confirm.
Step 4:
Select Tap mode
Menu>Sequences>Playback>Step Timing>[Tap mode]
Step 5:
Use the wheel to set On.
When TAP mode is on an asterisk is displayed in the bottom right position of the
LCD.
Step 6:
Press GO for each stack step at the appropriate time and the wait time is stored
for subsequent playback, independently for each of the steps. Only wait times
are affected by Tap mode.
Step 7:
Once a recording has been timed in this way Tap mode should be turned off to
play back with the recorded times.
Step 8:
Press EXIT to confirm and exit.
N o t e :
You can reset all wait times set with Tap to zero.