ETC SmartFade v3.0.1 - Manual (Page 59)

4
Edit 53
Edit step times blind
It is possible to edit the times blind, for each step of a Sequence or Stack. This is done with
the Step Timing - One Step function in the Sequences menu.
Step 1: Open the Set Sequences menu:
Menu>[Sequences]
Step 2: Use the wheel to select a Sequence (1-24) or the Stack (XF).
Press (MENU) to confirm.
Step 3: Use the wheel to select Step Timing.
Press (MENU) to confirm.
Step 4: Use the wheel to select One step.
Use (MENU) to step between choices, and wheel to set a value.
Step 5: Done. Press EXIT to exit.
Menu choice Console Feedback
Step:> Wheel Select step
U> Wheel Up time
D> Wheel Down time
W> Wheel Wait time