ETC SmartFade v3.0.1 - Manual (Page 46)

40 SmartFade v3.0.1 User Manual
Record the Stack from bumps
This function allows you to create the Stack with referenced memories or intensity
channels. The steps are created as each bump button for a memory or intensity is pressed.
Action Console Feedback
1. Activate record
sequence
All buttons that can record in this mode will
blink at full in yellow (press CLEAR to exit).
2. Choose Stack The moment the STACK button is pressed,
the button will light up in full. Now all bump
buttons can be stored as steps, and blink at
full in each fader mode.
2.5 If the Stack exists... Wheel If this display is shown:
Choose Erase & Make New or Append To
Existing with the wheel and press (MENU) to
confirm.
3. If desired, set the times
for this step
Wheel
4. Select a source for this
step
... or
...
You can select any memory or intensity
channel. Change fader page if desired.
When a bump button is pressed, that memory
or intensity will be stored as a reference to
this step.
Repeat steps 3-4 until satisfied.
5. End recording End recording. The console will return to the
fader mode prior to recording this sequence.
Press UNDO to skip the recording.
REC
SEQ
STACK
1 24
1 48
REC
SEQ