ETC SmartFade v3.0.1 - Manual (Page 78)

72 SmartFade v3.0.1 User Manual
Stack in Backup Mode
The Stack provided in DMX Backup mode consists of memories 1-24 (48) linked in order.
This Stack cannot be edited. Stack step 1 is the memory recorded to fader 1, etc.
Stack functions
By pressing STACK, the Stack is activated (lit at full) and connected to the Crossfader
controls.The cue stack is loaded onto the Crossfader at step 0 (a non-existent step before
step one) so that pressing GO, or starting a manual fade, will fade to step 1, which is the
memory stored in fader 1.
The LCDs will show the current state of the Stack, and the Up/Down time “Time:>5.0”,
which you can change with the wheel.
If there is nothing stored in the Stack, the button will be off completely when not activated.
otherwise it will be dimmed.
General Crossfader Controls. See “General Crossfader Controls” on page 60.
Jump to a step. See “Jump to step” on page 61.
STACK