Lenze HMI for visualisation / with control technology - Manual (Page 78)

Operation
Communicating via the CAN gateway function
Important notes
8
l
78 LDCDS−EL100 EN 9.0
8.5 Communicating via the CAN gateway function
8.5.1 Important notes
)
Note!
Devices with integrated PLC (EL 1xx PLC) may have troubled communication if
the following is not observed:
Before the CAN gateway function is used
ƒ Stop PLC by a reset.
ƒ Stop corresponding visualisation.
8.5.2 Establishing communication using the system bus configurator
How to proceed:
Start the system configurator.
1. Select Start
® Programs ® Lenze ® Communication ® System Bus Configurator on
your PC.
EL100−035