MK Diamond Scarifier - Manual (Page 20)

20
MK-Scarifier aSSeMBLY
Figure 3
A) Configure the Cutting Drum for Surface Prep.
B) Adjust the Cutting Drum Depth until the Cutting Discs are contacting the surface (increase
the depth of the Cutting Drum as necessary to increase the “roughness of the surface”
C) Scarifier in a smooth forward motion
D) Should the Cutting Discs loose contact with the surface, repeat Step B and continue for-
ward motion
E) Repeat Steps A through D until the desired roughness is achieved. (See Figure 3)
roughening or Preparing a Surface
Direction of Movement
Set depth to
contact the
surface
Maintain
set cutting
depth